10 Piece - Sharp Edge Polyhedral Dice Slab Mold - DND - Cap Style - Includes Two - D20's & Three - D4 Shapes

10 Piece - Full set mold. Including two D20's and three D4 shapes! For sharp edge polyhedral resin dice. Standard size. This is a cap style mold in a slab form. D20 X 2, D12, D10, D%, D8, D6, D4 (pyramid), D4 (shard), D4 (crystal), all in one unit!! There will be some clean-up work that will need to be done to the dice after demolding. Use fine grit sandpaper (wet/dry) or Zona papers. And a polishing compound. Be sure to use a CASTING resin. This is a non-food safe item. Commercial Free Font. If you would like the high numbers (20, 12, 0, 00, 8, 6, D4 2-3-4) on the cap/lid, just add a note to your purchase Thank you! Made in USA

• Mold for Creating Sharp Edge or Round Edge Polyhedral Dice - TTRPG - DND - Cap Style
• Total of 10 Molds in one Unit. D20, D20, D12, D10, D%, D8, D6, & three D4's (Crystal, Shard and Pyramid). Low number on the caps. If you would like the high number on the caps, please send us a message, or use the gift messaging to make a note. This is a NON food safe item
• Made of quality Platinum Silicone. This mold is intended for professionals creating dice to sell, or hobbyists. Creating molds from the dice that come from these molds is prohibited. The masters we use for these are uniquely our own. If you have any questions regarding this issue, feel free to contact us
• When going to demold, take your time to pull back the numbers slowly. Then bend and twist the mold to release the other numbers. Then work your dice out of the mold. The life of your mold depends on the care given during demolding. Also, do not use flame too close to the openings. This will also damage the mold
• We are not responsible for bubbles incurred during your process of making dice. It is highly recommended that you use a pressure pot during cure time at 20-40 psi
• Handmade in USA