Supercharger Pulley Pin Holding Tool HPT2000 Replacement Fits for Hellcat Challenger Charger Trackhawk 2015-up

Specification: Type: Supercharger Pin Holding Tool Fitment Type: Direct Replacement Placement on Vehicle: Front Material: Metal Color: As pictures show Manufacturer Part Number: HPT2000 Fitment: for 2015-up Challenger Charger Package includes: Supercharger Pin Holding Tool*1 (As shown in the figure)

• 【Fitment】The supercharger pulley pin holding tool is fit for Hellcat Challenger Charger Trackhawk 2015-up. Superseded Part Number: HPT2000.
• 【Function】This tool is designed to facilitate the removal of the original supercharger pulley. Once the supercharger snout is off the car and on the bench, this tool slides over the pins at the rear of the snout to hold the supercharger shaft stationary while the pulley is unscrewed at the front.
• 【Feature】This tool spreads the load over all eight pins, which is far better than using a pry bar against two pins. This tool greatly reduces the possibility of any breakage during the pulley removal process.
• 【Note】This tool is laser cut from 1/4" steel, and precisely machined to match the pin pattern and pin diameter. The hole in the center of the pin holes is designed to allow a 15mm socket to pass through to hold the shaft bolt if needed, and the slot at the handle-end will allow you to thread a snout fastener to positively lock the tool in place while the original supercharger pulley is un-screwed.
• 【Quality Service】Package Included: Supercharger Pin Holding Tool*1. If you encounter any problems in the process of using the product, you can contact us at the first time, and we will deal with it for you in time.