Wood Veneer Application Scraper Tool for Paper and Wood Backed Veneer Products

Wood veneer scraper application tool for lamination of wood veneer products. This is the ideal tool to scrape down and apply pressure to backed wood veneer sheet products. It also spreads and evens out the contact cement. You can use something similar, but this is the best way to do it. Make sure to file off any sharp edges so you do not cut the veneer. Trust the experience, knowledge, and reputation that has served the wood industry and novices since 1995. Visit My Store: JSO Wood Products We have all kinds of wood veneer products. Raw, backed, and edgebanding! Application Instructions A stiff scraper should be available at the start. Most contact cements work fine. Both flammable and water-based are satisfactory. Roller or brush grades seem to work better than faster drying spray grades. You should have a supply of bare, hardboard separator strips 1/8" thick hardboard or similar to completely cover the contact cement. At the very least two separators, half the width of the substrate is required. Don't attempt to lay wood veneer without having all the contact cement surface. Once contact cement surfaces grab, it will be too late to move the sheet. A. All open, hungry surfaces like Lauan, or Oak plywood will always require two coats of contact cement. B. Tight faced surfaces like Hardboard, or M.D.F. may allow one coat. Be generous with contact cement and aplly as smooth as possible. Coat both surfaces. If you spray apply the contact cement, do not apply dry, scant, open web pattern. 100% so no voids are left. Make certain you honor manufacturer's instructions as to open time. Wood expands across its grain in the presence of humidity. Un-mounted sheets of wood veneer left lying about may take on moisture making application difficult. 1. Make initial contact down the centerline. 2. Grasp the "east" flap. 3. Pull it taut. Stretch it so as to remove fullness and fluff. 4. Lower the tightly stretched flap as

• Brand: Wood veneer application scraper tool for sheets
• Model: Pressure application spread apply lamination