youyeetoo Sipeed Tang Primer 20K FPGA Development Board MCU, with LUT4, PMOD Port *4, for RISC-V and Embedded Development (with Dock ext-Board)

IntroductionTang Primer 20K is a DDR3 SODIMM-shaped core board based on the GW2A-LV18PG256C8/I7 main chip, with two expansion boards prepared: Dock and Lite.ParametersFPGA Chip: GW2A-LV18PG256C8/I7Logic units (LUT4): 20736Flip-Flop (FF): 15552Shadow SRAM (S-SRAM): 41472 bitsBlock SRAM (B-SRAM): 828K bitsNumber of B-SRAM: 4618x18 Multiplier: 48PLLs: 4I/O Bank: 8Memory: 128M DDR3Flash: 32Mbits NOR Flash (Read burn Flash)Debugger: Jtag + Uart (JST SH1.0 8Pins connector)SD card slot: 1 (Push-pull type)Display: 8Pins spi lcd connectorPackage: 204P DDR3Available IO: 117Quick Start: wiki.sipeed.com/hardware/en/tang/tang-primer-20k/primer-20k.htmlSupport: support @youyeetoo.comCommunication and customized consulting:am2 @youyeetoo.comForum: forum.youyeetoo.com (Recommend)

• 【Feature】Tang Primer 20K core board uses GW2A-LV18PG256C8I7 as the main chip, which has rich internal resources such as high-performance DSP, high-speed LVDS interface and BSRAM memory.
• Shipping list: Dock ext-Board package, 【WIKI】wiki.sipeed.com/hardware/en/tang/tang-primer-20k/primer-20k.html
• The core board is equipped with peripheral components such as DDR3 memory particles and power ICs, so that users can use the core board alone to quickly develop and verify projects for high-speed and low-cost applications.
• The Lite ext-board leads out many I0s through pin headers and PMOD interfaces, and users can easily connect other peripheral modules or circuits for secondary development.
• The Dock ext-board is equipped with a wealth of peripheral resources, such as onboard USB-JTAG & UART circuit, Ethernet PHY and RJ-45 connector, USB2.0 PHY, HDMI output interface, stereo output circuit and 3.5mm headphone connector, RGB Screen connector, DVP camera connector. 【ASIN】B0BNVQVHG6
• 【Minimalist IDE】Comapred with other FPGA IDE, the lDE which is used to develop Tang Primer 20K is really small, the hard disk capacity occupied after installation does not exceed 1G.